How to Synchronize Dash to ECU for Ford Focus after ECU Replacement

How to Synchronize Dash to ECU for Ford Focus after ECU Replacement

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



In this instruction car-auto-repair.com show you guide on how to use Ford All in One software to synchronize dashboard to ECU after new ECU replacement.

Procedures:

Step 1:Read out dashboard EEPROM file from dashboard

Connect Orange 5 programmer(or other programmer supported) to dashboard



Run Orange 5 software

Click “Type”–>”MC68HC12”–>”04-MTRK”–>”MC9S12H256”



Then read ID and read EEPROM to save the file on your PC

Here save it as name “eprom dash focus”



Step 2:Read out ECU file

Here you need use programmer to read out ECU file before perform synchronizing

Step 3:Synchronize to ECU

Run Ford All in One software

Open ECU eeprom file and dash eeprom file you read before



Click “Synchro to ecu” and save it on your PC



After then you can use Fairdell HexCmp2 software to compare new ECU eeprom file with original one.

And then check it work,use programmer to write the new ECU eeprom file back to ECU.

This article tech Supported by China OBD2,