ODIS Engineering Flashing Transmission DSG 7 DQ200 Unit

ODIS Engineering Flashing Transmission DSG 7 DQ200 Unit

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



This article show a guide on how to us ODIS Engineering software to flashing Transmission DSG 7 DQ200 Unit.

What You Need:

VAS5054A

ODIS Engineering Software

Procedures:

Connect VAS5054A to laptop and DSG 7 DQ200 unit,and supply power for DSG 7 DQ200 unit.

Run ODIS Engineering software,click “Admin” button at upper right corner.

Select “Function configuration” tag,then select “Flashing (Engineering)”

Make sure the options “UDS flash sessions” and “KWP control modules ” are not selected

Click the “Diagnosis” button at upper right corner to back to main views

Here i click “Vehicle project” to select “VwFLEET”,then click “Diagnostic Entrance” button

Then the ODIS Engineering software will load control modules as below

Select “042-Flash”

Select “0002-Transmission Control Module”,and click “Local flash file”

Select a file to load,and click “Start flashing”

It will prompt you warning massage as below,click “Yes” to continue

Do you want to flash all selected control modules?

Note:The flash process can take a long time when multiple containers are selected.

Make sure the power supply is sufficient

Switch the ignition off and on and then confirm this dialog

When it finish,it will prompt you “Would you like to clear all control DTC…”

Click “Yes” to continue

Done!

This article tech Supported by China OBD2,