Toyota Hilux 2010 G Chip 72 All Key Lost Program by OBD(OBDSTAR Key Master)

Toyota Hilux 2010 G Chip 72 All Key Lost Program by OBD(OBDSTAR Key Master)

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



This post test OBDSTAR X300 key master on Toyota Hilux VIGO 2010 G chip 72 all key programming.



And here are some related content:

Toyota All Key Lost Programming

Toyota G Chip Programmig

Toyota Reiz 2010 G Chip All Key Lost Programming

Procedures:

Toyota G chip key have G stamped on key



Connect OBDSTAR Key Master to vehicle via OBD port,and enter system menu to select “TOYOTA/LEXUS”à”TOYOTA/LEXUS V31.09”



For all key lost,when you insert the new key the security light don’t off



Turn on the ignition with new key



Operate the OBDSTAR Key master to select “Immobiliser”



Select “Type 2(With G 72)”



Select “Reset immobiliser” (All keys lost)



Follow the prompt to switch ignition off



Then it will prompt to switch ignition on.



Switch the ignition off and remove the key,the press the “ENT” button to continue



Switch ignition on



Now the security light steady prompt



Switch ignition off and remove the key



Then OBDSTAR Key Master will show you below options:

Program keys as the following steps within 120 seconds:

A:Program 2 master keys and 1 sub keys.

1.Insert the first master key,turn on the ignition,and wait for seconds

2.Insert the second master key,turn on the ignition,and wait for 5 seconds.

3.Insert the third sub key,turn on the ignition switch,and wait for 5 seconds.Security light turn off,and programming is finished



B:Program 1 master key and 1 sub key:

1.Insert the first master key,turn on the ignition ,and wait for 5 seconds

2.Inser the second sub key,turn on the ignition switch,and wait for 5 seconds.

3.Turn on the ignition on switch quickly for 5 times.Security light turns off,and programming is finished.

C:Program 1 master key:

1.Insert the master key,turn on the ignition,and wait for second.

2.Turn on the ignition switch quickly for 5 times.Security light turns off,and programming is finished.

Now the security light is off when you turn on ignition,and it can start the engine.



This article tech Supported by China OBD2,