Honda HDS HIM All Key Lost Programming for Accord V6 2007

Honda HDS HIM All Key Lost Programming for Accord V6 2007

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



Most people believe the Honda HDS HIM is special diagnostic software for Honda vehicle model,but it not only a diagnostic tool,but also a key programmer for Honda.So here I want to share this Honda HDS HIM Key Programming guide to you.

Preparation:

Newest Honda HDS V3.102.038 Free Download

Aftermarket Honda HDS Multiplatform Software Installation

How to Install Honda HDS Software for DIY

V3.102.004 HDS HIM Honda With Double Board($99)

TOOGOO(R) Honda HDS HIM V3.012.023 from Amazon($120.87)

Honda HDS HIM Key Programming Guide:

Connect Honda HDS HIM device to your vehicle by OBD port.

Run the Honda Honda HDS HIM software and enter “System Selection Menu”

Select “IMMOBI”

Note:Not all system may be available on this vehicle.Refer to the Service Manual for further information



Keep ignition ON until the tester directs you to turn the ignition off.

Press[Enter] to continue



The tester cannot program keys with T5 stamped on the blade of the key or with the word ILCO on the plastic head.These keys can only be programmed with the ILCO key duplicator.

Press[Enter] to continue



Determining immobilizer system type.Please wait.



Select “Immobilizer Setup”

IMPORTANT:

For vehicle equipped with keyless Access System,use the actual immobilizer key in the remote to register and diagnose the system



Then you will see there are 5 options as below picture:

Before programming new keys,you would better to check the number of key.Select “System Check,Number of Keys and Status Log”à”Number Of Keys”



It show there is 1 key registered



Then Exit the selection and select “Add and Delete Keys”

This function does the necessary registration for registering new keys or deleting registered keys



Select “All Key Lost”



It prompt “Obtain PCM-code(IMMOBILIZER PCM CODE) for In

This vehihcle’s VIN will be required to obtain the password”

Check this article: How to Get PIN Code When Programming Key



Enter PCM-Code



After input the PCM code,it prompt you to enter the key number you want to register.

Here enter “1”



Then follow the Honda HDS HIM software operations:

Turn the ignition switch off

Then turn the ignition switch on



Turn the ignition switch off within 16 seconds



Turn the ignition switch to on within 20 seconds,without changing the key



Turn the ignition switch off

Then turn the ignition switch on

It prompt that “Is the immobilizer indicator light turned off?”

Click “Yes” to continue



Turn the ignition switch off

Turn the ignition switch on

Turn the ignition switch off

Turn the ignition switch on again

The registration of keys has been completed.

Turn the ignition switch off



Check All Keys to ensure each will start the engine



Done!

This article tech Supported by China OBD2,