How to use Toyota TIS Techstream to Register Recognition Code

How to use Toyota TIS Techstream to Register Recognition Code

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



It is necessary to register recognition code when replace door control transmitter or door control receiver.So here i will share how to use Toyota TIS Techstream to register recognition code.Hope it helps!

Note:For detail procedures,refer to the prompts on the Techstream screen.The number of currently registered codes can be checked on the first screen of Wireless Code Registration.

Preparations:

Toyota TIS Techstream Video+PDF Tutorial

Latest Toyota TIS Techstream V13.10.019 Software Free Download

Toyota TIS Techstream v12.20.024 Installation Guide

How to use Toyota TIS Techstream

Procedures of Recognition Code Registration:

1.Turn the ignition switch to ON

2.Enter the following menus:Body Electrical/Main Body/Utility/Wireless Code Registration

3.Press both the lock and unlock switches at the same time for 1 to 1.5 seconds.

4.Press either switch for more than 1 seconds within 3 seconds.

5.Check the response to the registration completion.

Response to Registration Completion:

Main body ECU automatically performs power door lock-unlock operation to show whether registration has been completed correctly or not.



If the lock-unlock operation occurs twice,the registration of the recognition code has failed.Perform the registration procedures again from the beginning.

If registering another transmitter,repeat the procedures after the Techstream operation.All 6 recognition codes can be registered consecutively.

6.Perform either of the following to complete the registration of the recognition codes:

Use the Techstream to send a completion command.

Disconnect the Techstream.

Done!

This article tech Supported by China OBD2,