Cummins Insite Reset Aftertreatment System after DPF Clean for CM2250

Cummins Insite Reset Aftertreatment System after DPF Clean for CM2250

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



This instruction show you guide on how to use Cummins Insite software to reset Aftertreatment system after DPF clean for Cummins CM2250 engine ECM.



Preparations:

Newest Cummins Insite 8.6 8.4 Free Download

Procedures:

Connect Cummins Insite interface to diagnostic port

Then run software and connect to ECM,after then select “Advanced ECM Data”



Then select “Aftertreatment Maintenance”

This feature provides the ability for a technician to install and reset the Aftertreatment System.

Select “All” from Reset Options and then click “Reset” button to continue



Please turn the Key Switch off,and then click “OK”



Waiting 30 seconds before allowing for Key On



Please turn the Key Switch on,and then click “OK”



A process was successful



Now if you installed a new filter,we back to select “Aftertreatment Maintenance Filter Installation”

This feature resets the ECM system after a new aftertreatment filter has been installed.



This article tech Supported by China OBD2,