Porsche Panamera Level System Air Spring Replacement Programming by X431

Porsche Panamera Level System Air Spring Replacement Programming by X431

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



This instruction show you Launch X431 programming Porsche Panamera level system after air spring replacement. More post about Porsche repair,please check here:Porsche trouble repair.

Caution:

Ensure the supply voltage is not under 12V during the operation.

Other operations should meet the requirements prompted.

Operation Guideline:

1.Select Porsche Version V21.80 or above.

2.Select automatic search

3.Select rapid test, click YES.

4.Select Level Control

5.Select version information.

6.After confirming the Porsche part number and diagnostic software number, click OK

7.Select special function.

8.Select replacement of air spring

9.Click [Charge an air spring]

10.Click OK, enter the interface and view the status and value of the battery voltage,ignition and engine speed

11.Click Next, select the second item of air spring selection, it appears 4 options of front left, front right, rear left and rear right

12.Select air spring selection

13.For example, select the second item [Front right], click [Start], the value of “Inflate air springs using pressure accumulator” and “Conclude filling process” changed from “wait” to “function completed”, and the status is OK

14.After the front right item, click [air spring selection] to select any one of front left, rear left and rear right. Click [Start]

15.To bleed the air spring, click [air spring ventilation] in the special function

16.Click OK, enter the interface and view the status and value of the battery voltage, ignition and engine speed

17.Click Next, select the second item of air spring selection, it appears 4 options of front left, front right, rear left and rear right

18.Select [Front right].

19.Click [Start], pay attention to the prompt, the value of “bleed air spring” changed to function completed and the status is OK

20.After the front right item, click [air spring selection] to select any one of front left, rear left and rear right. Click [Start], repeat the above two steps

More Launch X431 Training article,please check here:Launch X431 use guide

This article tech Supported by China OBD2,