How to Solve Renault CAN Clip Firmware Update 20% Error

How to Solve Renault CAN Clip Firmware Update 20% Error

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



Many Renault CAN Clip users feedback that they got the firmware update stop at 20% error,so here I collection some solutions for this problem.Hope it helps!

Related Contents on Renault CAN Clip:

Renault CAN Clip Software v185 v183 All Version Free Download

Renault CAN CLIP Clone Interface

Solutions for Renault CAN CLIP Firmware Update Error:

Solution 1:

This method work for most Renault CAN CLIP said by members from forum.

Must rename the following files:

C: \ CLIP \ DATA \ APPLI \ PARAMS \ appliiso.s19 in appliiso.bak

C: \ CLIP \ DATA \ APPLI \ PARAMS \ applican.s19 in applican.bak

Solution 2:

if firmware update stops at 20% the solution is very easy

Exist some problems in hardware … ISO pcb or CAN pcb

For bypass that error search for 2 files APLIISO.S19 and APLIICAN.S19 and rename this files to .bak one time ISO …start the soft and ceck …. and one time CAN and restrt the soft and ceck…and you see where is the problem CAN hardware or ISO hardware….

The files is located here :

C:\ASDE\MODULES\

C:\CLIP\DATA\APPLI\PARAMS\

If you have renamed the right file no more firmware stop at 20% but the problem on hardware remain and is possible use the interface only for ISO or only for CAN vehicles…..or put the interface in trash !!!!

BUT, some say the exactly reasons for 20% update problem is not the software problem! It’s HARDWARE problem with your clone CLIP sonde. You probably have bad flash chip or bad soldering, or bad oscillator, or, … you name it, but anyway as I said it’s pure hardware problem. You can avoid firmware update for ISO or CAN board with renaming few files, but that is not solution because if you can’t update firmware, your CLIP will not work properly.

Solution 3:

Besides two pcb’s inside Clip (can and iso) there is small thrid pcb where is round connector for car cable . When this cable is plugged and unplugged to Clip very often ( which needs a little force ), then solderings on metal pins which links this small pcb with rest of clip are breaking with the time.

You just need to resolder connections of these pins.

I did it and it solve update 20% problem

This article tech Supported by China OBD2,