G-scan2 Teach in Component Function Test on BMW X5 2009 Transmission

G-scan2 Teach in Component Function Test on BMW X5 2009 Transmission

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



Here is a test report on how to use G-scan2 to perform “Tech-in Component” function on BMW X5 2009 transmission system.

Procedures:

Connect G-scan2 to BMW X5 2009,then enter the “Diagnosis” menu to select “BMW” to identify vehicle.

After vehicle identification,select “EGS(Electronic transmission management)”

Select “Special Function”

Select “Tech In Components”

Now it will show the instruction of Teach In Components

“The teach-in function may have to be reset in the following cases:

–Trailer module retrofit

–Acc retrofit

–Incorrect installation of finial drive unit

–Incorrect installation of automatic transmission

–Replacement of szl control unit”

Then select “OK” to continue

Then it will show “Complete” massage,it mean the component learning procedures complete.

This article tech Supported by China OBD2,