FCOM Reprogram/Configure ECU for Ford Focus 2008

FCOM Reprogram/Configure ECU for Ford Focus 2008

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



This instruction show the steps on how to use FCOM to re-configuration of an ECU using AS-BUILT data function for Ford Focus 2008.

Preparations:

FCOM Ford OBD2 Diagnostic Software Download

How to Install FCOM Diagnostic Software on Window/Linux

Procedures:

Connect FCOM interface to vehicle OBD port,then run FCOM software

Click “Select Control Unit”

Select “IPC-Instruments panel cluster”

Select “Configuration” under “Expert functions”

Select “As-Built data”,then click”Go” to continue

Select “720-01-01,2C69 0040 807E”,then click “Exit”

Here input “CD7201408029”

Click “Write configuration to ECU”

It will show below warning massage,click “Yes” to continue

Reprogramming successfully

This article tech Supported by China OBD2,