G-scan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011

G-scan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



In this article,G-scan2 test the G-Scan2 diagnostic tool BMW DME special function on BMW 302I 2011.And for more G-scan2 diagnostic tool test report,check here:G-scan2 test report

Procedures:

Connect G-Scan2 to the BMW 320I,and the select “Diagnosis” menu and then select BMW 320I 2011 model.

After then select “DME(Digital Engine Electronic)”,click “OK” to continue

Select “Special Function”

Select “Clear adaptations”

The adaptation values can be reset in the next test step,click “F1” to start resetting adaptation values.

Then i will show you adaptation values were reset.

Switch off terminal 15 and terminal R

Wait 15 seconds until the reset adaptation values and variants are stored in the DME,then press “OK” to continue

Switch on terminal 15

Leave ignition switched on for at least 10 seconds,press “OK” to continue

Service function finished

This article tech Supported by China OBD2,