Benz W210 FBS 3 All Key Lost Programming by Zed-Full Programmer
Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3In this article,i will show you step-by-step guide on how to use Zed-Full programmer to perform all key lost programming for Benz W210.
Benz W210 All Key Lost Programming:
Power on Zed-Full,enter menu to select [MB IR-PROG]
Select [Program]
Select [Lost Key]
Note:If there is no working key available use this option (all key lost)
Select [SERVER (FBS 3 System)]
Note:ZFH-MCA,Zed-NET,IR-PROG,ZFH-C09 parts are required for this application
Connect ZFH-C16 cable to ZFH-MCA adapter
Connect Zed-NET to ZFH-MCA adapter
Connect ZFH-C15 to ZFH-MCA adapter and connect ZFH-UTE to ZFH-C15 cable
Connect ZFH-C10 to ZFH-MCA adapter and connect IR-PROG to ZFH-C10 cable
Connect ZFH-C16 cable to EXERNAL PORT on Zed-Full back port
Press Continue button
Press on [Select System (C09)] and select “CLASS E W210” EZS/EIS type on list
Connect ZFH-09 cable to [OBD2 DONGLE] port on Zed-Full back port
Connect ZFH-C09 cable pins to related pins on EZS/EIS socket as shown on Zed-Full screen
Make sure ZFH-C09 pins are connected to EZS/EIS pins properly and press on Continue
Data is being read from EZS/EIS unit.
Press continue button on Zed-Full screen
All required ZFH-MCA connections have already been done.Now insert ZFH-UTE to EZS/EIS (ignition) and press Continue button
Successful
Zed-NET has already connected to this Wi-Fi network
For password calculation ZFH-UTE must be connected to EZS/EIS unit.
To start process press on Continue button
Each password calculation will take about 30 minutes.
30 minutes later
The password calculation will take up to 2 minutes
If password calculation fails,Zed-Full will continue the process automatically till calculating password.After password calculation,key list will be viewed on Zed-Full screen.
Either Empty or Used marked slots can be selected to program a new key.(“Used” marked slots shows the existing programmed keys on this car memory)
In this case programming a new key on a “Used” marked slot,new programmed key will start the car but same slot old key will not.
Here select “3-Used”,and press Continue button
Key data is generated
Select “EA Key (IR)”
Put “EA” version key to “IR-Prog” and press “Program” button
“EA” version key is being programmed to to the car.
Wait for proceed
This article tech Supported by China OBD2,
No comments:
Post a Comment