Autocom CDP+ Reset Counter for Additive Level for Peugeot 308 2010

Autocom CDP+ Reset Counter for Additive Level for Peugeot 308 2010

Chinaobd2 is a leading supplier of all kinds of Car Diagnostic Tool, Truck Diagnostic Tool, OBD2 Code Reader, Car Key Programmer,ECU Chip Tunning,etc. Currently, the top selling product including: VCDS VAG COM Cable, iProg+ Programmer, Scania VCI3



This mini post show you how to use Autocom CDP+ reset counter counter for additive level for Peugeot 308 2010.

Procedures of Resetting Counter for Additive Level:

Connect Autocom CDP+ to Peugeot 308

Then run autocom software and enter to select vehicle model

Brand:Peugeot

Model:308

Year model:2010

Type of system:Diesel

Engine code:Additive system

System:Multiplex

Then it will show you conditions:

1.Turn ignition on or start the engine

2.Start measuring

3.Choose the test or tests you want to perform

4.Exit measuring

5.Turn ignition off

Click “OK” to continue

When communication established

Choose function by using the buttons in the left menu

Tip:Move themouse pointer over the buttons to see a hint describing the function

Click the “Adjust” button in the left menu

Now select “Replacement of the additive tank”

Then it will show you screen as below,and please check the help information,after then click “OK” button to start resetting.

Help information:

This function is used to restore the counter for calculating additive level in the reservoir.The function shall only be done after replacement or filling additive reservoir according to service instructions for the car.Only change to reservoir of same volume.

Test conditions:

Ignition on,engine off.

All power consumers disconnected.

Battery voltage above 12V

Additive reservoir replaced or filled

Procedures:

1.Start the function

2.Follow the instructions in the programme.

3.Finish and disconnect the diagnostics unit

4.The function is done

If the function failed,check test conditions and resolve any error codes.

This article tech Supported by China OBD2,